Is Granite Hard to Maintain? Granite vs Marble vs Stone-Look Tiles
Photo: HDB void deck at 497 Tampines St 45 by Yuqiao, Wikimedia Commons, licensed under CC BY 4.0.
Short answer: no. Granite is one of the easiest natural stones to maintain: it is hard, resists scratches and heat, and only needs a pH-neutral cleaner day to day. Its weak point is staining, since many granites are slightly porous and need sealing. Marble needs more care than granite. Stone-look porcelain needs the least.
What granite maintenance actually involves
- Daily: sweep, then mop with warm water and a neutral stone cleaner.
- Spills: blot oil, curry, coffee and soy sauce quickly, especially on lighter granites.
- Sealing: depends on the stone. Dark, dense granites may need little or none; lighter, more porous ones benefit from periodic sealing.
- Avoid: bleach, vinegar and abrasive pads, which wear down sealers and polish.
Granite vs marble: which is easier to look after?
On site, "granite" and "marble" often get used as if they were the same thing. They aren't, and the difference shows up within months in a busy lobby or corridor.
| Granite | Marble | |
|---|---|---|
| Hardness | Very hard, resists scratching | Softer, scratches and wears faster |
| Acids (vinegar, lime, some cleaners) | Largely unaffected | Etches: leaves dull marks on polished surfaces |
| Staining | Low to moderate, sealing for lighter stones | Higher, sealing recommended |
| Polish over time | Holds well | Dulls in high-traffic paths, needs re-polishing |
| Wet grip (polished) | Slippery | Slippery |
| Best suited to | Lobbies, stairs, high-traffic floors | Feature walls, low-traffic indoor floors |
The practical takeaway for common areas: polished natural stone of either kind is slippery when wet. For anything exposed to rain, wash-down or hawker-centre spills, you want a matte or anti-slip finish, which is where porcelain wins.
The lowest-maintenance option: stone-look and marble tiles
If you want the look of stone without sealing or re-polishing, porcelain is the answer. It is dense, doesn't absorb stains, isn't affected by acidic cleaners and comes in anti-slip finishes.
- MP Series: matte, natural stone appearance with anti-slip performance for corridors and lobbies.
- Marble tiles: we carry marble tiles in selected ranges for feature walls and indoor areas.
We supply tiles, not slabs. If your spec calls for a marble or stone look we don't stock, our sourcing team can find a match. Tell us what you need.
Looking for a hard-wearing, non-slip finish for outdoor pathways or playgrounds instead? See what granolithic chipping is.
Frequently asked questions
Does granite need to be sealed?
Some granites do and some don't. Lighter, more porous granites benefit from sealing to resist stains; very dense, dark granites may need little or none.
Is marble harder to maintain than granite?
Yes. Marble is softer, scratches more easily and etches when it contacts acids such as vinegar or lime, so it needs sealing and occasional re-polishing. Granite is harder and largely unaffected by acids.
What is the lowest-maintenance stone-look floor?
Matte porcelain stone-look tiles. They don't need sealing, resist stains and acidic cleaners, and are available in anti-slip finishes.
Does Forte 18 supply granite or marble slabs?
No. Forte 18 supplies tiles, including marble tiles in selected ranges and stone-look porcelain. We can also source specific tiles on request.
Need help choosing? Send us your area and requirements and we'll recommend tiles and quantities.